Design News – January 12, 2004 – Technology you can use
Similar Posts
MDS – Material Performance, September 1999
The standard metal face seal fitting is used throughout the semiconductor industry on process lines that span the range from high pressure to high vacuum. Leakage of fluids out of a system may be catastrophic in those containing toxic, corrosive, or pyrophoric materials. Leakage of moisture and particles into a system has a negative impact…
Flight Qualification of Omnisafe Anti-Torque, MultiMate/Demate Fitting – Joint Propulsion Conference 2005
Flight Qualification of Omnisafe Anti-Torque, Multi Mate/Demate Fitting Raymond S. Baker and David P. Bame Jet Propulsion Laboratory, California Institute of Technology, 4800 Oak Grove Drive, Pasadena, CA, 91109
Test Methods for the Performance and Evaluation of Metal Face Seals for Use in Fluid Delivery Systems – SEMI
SEMI – August, 2002 Test Methods for the Performance and Evaluation of Metal Face Seals for Use in Fluid Delivery Systems This test method was technically approved by the Global Gases Committee and is the direct responsibility of the North American Gases Committee. Current edition approved by the North American Regional Standards Committee on August…
Solid State Technology April 1997
“New Torque Suppressor Cures Problems of Metal Seal Face Fittings” Solid State Technology, April 1997